Author Topic: UP Studio V 1.0 update  (Read 75 times)

Offline JesseVoss

  • Newbie
  • *
  • Posts: 5
  • Karma: +0/-0
UP Studio V 1.0 update
« on: May 30, 2018, 03:09:23 PM »

Great to hear John, it's a job for me this weekend. What printer do you have, is it the UpBox? Also can you let me know the settings you used, I've had two failures so far about 5 hours in, so would be interested in your settings if you get a successful print. The designer in the comments section on thingiverse advised it should be able to be printed without supports. My failures were both around adhesion of the columns to the base of the model.

Please help

I didn't find the right solution from the internet.

Video advertising company

Thank you