Author Topic: Issue 216 - 3D Printers  (Read 71 times)

Offline JesseVoss

  • Newbie
  • *
  • Posts: 5
  • Karma: +0/-0
Issue 216 - 3D Printers
« on: May 24, 2018, 04:24:29 PM »
Hello,

However I must say I think you were very hard on the Prusa i3, and scored it quite low. Why so I say this..I really think that when you come to do "Roundup" tests on Hardware, you really should have a "Price/Cost" Verdict.The price of this printer should be taken into consideration for a few reasons.. one you scored it low for ease of setup.. I can understand that,, but when you are only paying 400 what do you expect? When you pay well over 3000 you would expect just to plug and play.If taking the price into consideration I would put it at joint second with 4 stars rather than the 3 you gave it.. Obviously this is my humble opinion, but I would ask that you look at adding Price/cost in future..

Please help.

I didn't find the right solution from the Internet.

References:-
https://linuxformat.com/forums/viewtopic.php?f=3&t=17266
Creative infographic design service

Thanks