Author Topic: We have a D290  (Read 2526 times)

Offline Barry

  • Newbie
  • *
  • Posts: 1
  • Karma: +1/-0
We have a D290
« on: July 05, 2013, 11:16:10 AM »
To get this group up and running - we have just got our new Inspire D290 running and are getting to know it.

We have been using an Up! for about 2 years which was a great introduction to the technology but was rather hard work in our industrial environment.

We are a special purpose machine builder and do lots of prototyping since everything we do is a new design. Our expectation is the printer will help with prototyping but we do not expect to make production parts.

After a week of use we are off to a pretty good start with some good sized parts - a couple of successful 14+ hour builds. There is going to be some learning about the best settings but so far the table system and the heated chamber looks like it will cope pretty well with challenging larger parts.



Offline Domenic

  • Newbie
  • *
  • Posts: 8
  • Karma: +0/-0
Re: We have a D290
« Reply #1 on: July 25, 2013, 01:37:06 PM »
Hi Barry,

How are you going with the D290 after a few weeks of printing?
Inspire S250