Author Topic: Windows 8 driver installation  (Read 2941 times)

Offline dale3dps

  • Administrator
  • Jr. Member
  • *****
  • Posts: 68
  • Karma: +0/-0
    • 3D Printing Systems
Windows 8 driver installation
« on: April 10, 2013, 01:47:36 PM »
If you are using Windows 8 and need to install the UP software you can use this guide http://3dprintingsystems.com/download/Windows_8_Driver_installation.pdf.
It has step by step instructions for install the 3D printer drivers.


| Sales and Support | www.3dprintingsystems.com | Skype: dale3dps

Offline Ian K

  • Newbie
  • *
  • Posts: 16
  • Karma: +2/-0
  • Once a Jolly swagman always a jolly swagman!
Re: Windows 8 driver installation
« Reply #1 on: July 26, 2013, 10:57:35 AM »
Dale:
I had trouble installing the Windows 8 drivers until I discovered where I went wrong!  . . . . I followed your directions . . . on page 2 of the PDF instructions you supplied, it refers you to the (circled in red) "Control Panel" when in fact it should refer you to the "Change Settings" command at the bottom right hand corner of the settings screen.
Once clicked, everything else is O.K. and as your PDF instructions show.
Cheers IanK
One good turn . . . . .  gets most of the blanket!

Offline dale3dps

  • Administrator
  • Jr. Member
  • *****
  • Posts: 68
  • Karma: +0/-0
    • 3D Printing Systems
Re: Windows 8 driver installation
« Reply #2 on: July 29, 2013, 09:56:18 AM »
Hi Ian,

Thanks, I will had a look and amended the instructions. Hopefully it will help others using Windows 8.
| Sales and Support | www.3dprintingsystems.com | Skype: dale3dps