3D Printing Systems Community

General Category => Software for 3D Printing => : dale3dps April 10, 2013, 08:15:51 AM

: Best settings for 3D printing Lithophanes using Photo2Mesh
: dale3dps April 10, 2013, 08:15:51 AM
Photo2Mesh software settings:
The most important settings are Z height & Mesh height.

UP printer quality settings:
Ensure your orientation is set such that the photo is printed vertically on its thin side edge NOT flat straight, else it will fail. It also pays to position such that the layers are perpendicular to the ground. I.E. if its portrait photo, print on its longer side down, landscapes print on shorter side down.

If you haven't seen or don't know about Photo2Mesh you can find out more here http://3dprintingsystems.com/products/software/photo2mesh/ (http://3dprintingsystems.com/products/software/photo2mesh/).


: Re: Best settings for 3D printing Lithophanes using Photo2Mesh
: joliecarter May 29, 2015, 07:49:13 PM
Thanks for sharing this information. I guess these settings are working for me.