Author Topic: Preheating Tip  (Read 1837 times)

Offline bruce3dps

  • Administrator
  • Jr. Member
  • *****
  • Posts: 58
  • Karma: +5/-0
  • Join the revolution!
    • 3D Printing Systems
Preheating Tip
« on: July 30, 2014, 09:20:11 AM »
This is a preheating tip:

Move the platform up to the level where the hot air comes out the side vents, then preheat the chamber before printing for 15-20 mins. This will make the table nice & toasty before sending a print.

Even if you are printing at hot or cooler chamber temps, the above tip works well and getting great adhesion to the platform.