Author Topic: Suggestion for software  (Read 2580 times)

Offline Dave Everett

  • Newbie
  • *
  • Posts: 2
  • Karma: +1/-0
Suggestion for software
« on: June 20, 2014, 04:18:52 PM »
As it is recommended to close the fan gate after printing the raft. It would be nice to have an option for the printer to pause at that point so you can close it. It is near impossible to do while the printer is running.




Offline dale3dps

  • Administrator
  • Jr. Member
  • *****
  • Posts: 68
  • Karma: +0/-0
    • 3D Printing Systems
Re: Suggestion for software
« Reply #1 on: June 26, 2014, 01:58:46 PM »
Hi Dave,

When you send a job to the printer, there is a text box at the bottom of the print screen "Pause at:". If you put 2 (mm) it will pause the printer after laying down the raft. To resume the print, open the maintenance screen and click 'Resume print'.
| Sales and Support | www.3dprintingsystems.com | Skype: dale3dps

Offline Dave Everett

  • Newbie
  • *
  • Posts: 2
  • Karma: +1/-0
Re: Suggestion for software
« Reply #2 on: June 27, 2014, 08:14:14 PM »
Thanks, I wasn't quite certain what height the raft was.

Even better in the future would be if the fan could turn off after printing the raft.

I'm good at thinking of ways for you to work harder :)

Dave

Offline joliecarter

  • Newbie
  • *
  • Posts: 4
  • Karma: +0/-0
Re: Suggestion for software
« Reply #3 on: May 26, 2015, 06:32:38 PM »
I think you should try MyPRINTCloud's Print MIS. They are the best Print MIS and Web to Print solutions provider around the globe. They even make customized softwares for their clients. I hope it helps.

Heres the website:
http://www.myprintcloud.com/