Author Topic: Move Error Randomly through prints  (Read 1653 times)

Offline AprilStorm

  • Newbie
  • *
  • Posts: 2
  • Karma: +0/-0
Move Error Randomly through prints
« on: May 18, 2015, 02:45:53 PM »
I have two Up Minis.  So far they have proved to be very reliable machines, but recently one, the newest started stalling on prints.

All I get back in the software is the condition "Move Error" in the status bar.  The machine is less than 12 months old.

I have looked online and one of the suggestions was to clean and lubricate the rods to ensure there is nothing obvious blocking.  I have done this, and while it worked once, since I still get this error on everything taller than 6cm.

Any ideas?  Should I just return the machine under warranty or is there something obvious I can do?